Flashing the WRT54G-TM: Download the DD-WRT firmware: mega build 14929 (newer is suggested ) Refer to the Firmware FAQ and Peacock thread. The instructions for accomplishing this are described in Dnsmasq-discuss Setting different default gateway by mac address. In my case, I wanted to assign.It took me a few tries to get it to trigger a proper MAC address.I do remember it being stuck at all 0's at some point, and I had to delete/re-add it after doing the Random/Default thing, and then copy the MAC that it ends up listing (it says something like, "Router reports MAC as."), and that fixes it.Now, I can disable/re-enable my Guest WiFi all I want, with no issues what so ever. Enter the 12-digit MAC address of your old router, then click OK.With Wireless MAC Filter enabled, only MAC addresses you specifically allow in your Linksys routers configuration interface can connect to your wireless.Click to expand.Yes, I randomized everything - saved (no reboot), then went to Default - saved (no reboot). At some point, going to the page for my Guest WiFi (lets say, WL0.1), it said that the MAC was being reported as something else (other than what Random/Default reported as, and other than all 0s), so I copied and pasted it into the MAC address field, and voila.Linksys WRT54G-TM and WRT54G-RG are identical in terms of hardware but not the firmware so the CORRECT FILES MUST BE USED.
![]() Address For Linksys Usb Download The DDLocate the MAC address on the Linksys Print Server box just below the Serial No and take note of it.4. Click on properties, then double-click on Internet Protocol (TCP/IP) & assigning an unused IP address accordingly.3. Then double-click on Local Area Connections. Assign a static IP address that is similar to range of your network to your notebook or PC's network adapter first.This can be done by going to Control Panel, double-click on Network Connections. After a hard reset of the print server, connect a LAN cable directly from print server's Ethernet port to your PC or notebook's network port.2. You may need to do the Random/Default again, after you've re-added it. ![]() Start a web browser and type IP address of the print server in the URL locator.9. Check the IP address and MAC address if this step does not work.8. If not power cycle the device. You should get a reply from the print server. Near reality download for macClick on the Protocol tab, TCP/IP & assign the TCP/IP information for device. Wait for all lights on the printer server to turn green before continuing with the setup.12. Once connected, uncheck AppleTalk & NetBEUI if it is not required then click save.11. The default password for Linksys is usually admin with blank username field.10. ![]() Typical steps after this would be at the client's PC, go to Start, Control Panel, Printers, click Add a printer then next, then click Add a printer using a TCP/IP address then next, type IP address of the print server then next, leave as generic network card and default for all else then select have disk & browse to the location of your printer driver to complete installation. You may resume your setup by connecting a printer to the USB port of the print server then set it up on client's workstation that are printing to it.19.
0 Comments
Leave a Reply. |
AuthorValerie ArchivesCategories |